Connect the Linksys serial cable that came with the switch between the switch serial port and a nearby computer serial port. For Linux, use minicom. The switch default serial port configuration is set to baud, 8 data bits, no parity, 1 stop bit, no flow control. Confirm that you have a valid serial connection by pressing enter a few times. You should be prompted with a login screen.
|Published (Last):||25 November 2014|
|PDF File Size:||17.6 Mb|
|ePub File Size:||13.94 Mb|
|Price:||Free* [*Free Regsitration Required]|
Mezicage You must configure a mask for an ACL rule before you can bind it to a port. Check Enabled and choose a Policy Map for a port from the drop-down menu.
Global settings apply icsco the entire switch. Glossary This glossary contains some basic networking terms you may come across when using this product. System Information Page 22 — Figure This switch supports up to four lags. Side Panel Figure Click the Submit button to start the test. Page 38 — Figure Discussion threads can be closed at any time at our discretion.
Select an icon for the application. DiffServ Policy Map — Setti These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. Spanning Tree — Information Figure Switch Config — Port Mirror You may use a different priority or path cost for ports of the same media type to indicate the preferred path, link type to indicate a point-to-point connection or shared-media connection, and edge port to indicate if the attached device can support fast forwarding.
Page srw22p4 — Appendix B: Fiber Optic Port Safety When using a fiber optic port, rswp look at the transmit laser while it is powered on. Modify Name and Description. Indicates the type of flow control currently in use. This user guide covers the steps for setting up and using the Switch. This switch provides more efficient throughput for large sequential data transfers by supporting jumbo frames up to bytes.
This switch supports CoS with four priority queues for each port. For static lags, the switches have to comply with the Cisco EtherChannel standard. When enabled, the switch will monitor network traffic to determine which hosts want to receive multicast traffic. Related Posts
Cisco SRW224P 24-port 10/100 + 2-port Gigabit Switch - WebView/PoE
Cisco Default Password List