CRYPTEX INSTRUCTIONS PDF

Step 6: Constructing the Rings and Spacers The rings are constructed from three circles and each come with a spacer. Here are the parts to building four rings: 4 62mm circles with 45mm holes spacer, notched 4 79mm circles with 45mm holes notched 4 80mm circles with 45mm holes notched 4 80mm circles with 65mm holes 4 20mm strips The notched parts have 10x10mm notches cut out which line up once the ring is constructed. Start by gluing the 80mm circle with 65mm hole on to the 79mm circle with the 45mm hole. This outer circle is used to hide the spacer. Cut out the 10x10mm notch that is illustrated in the photos above. Do this step four times.

Author:Dobei Tygogore
Country:Sao Tome and Principe
Language:English (Spanish)
Genre:Health and Food
Published (Last):14 October 2007
Pages:475
PDF File Size:2.70 Mb
ePub File Size:14.15 Mb
ISBN:824-7-50123-401-5
Downloads:73025
Price:Free* [*Free Regsitration Required]
Uploader:Fenrirr



Because we need to make multiple rings, we are going to use parameters to allow us to quickly change the text on the ring. Step 1: Create a work plane that is offset from the outer surface of the ring in the XZ plane I spaced mine off two inches, so I could still see the ring without interference. Step 2: Create a new sketch on that plane. Step 3: Using the text tool, type the alphabet, inserting a space in between every letter.

Center justify the text to make it look neat. Step 4: This is where you get to explore a bit. Choose your font, and measure from letter A, to letter Z. This is a critical dimension, because it wants to be as close to the circumference as possible. I added an A after the Z, and then measured from the top of the first A to the top of the second. From there, I adjusted the font size until that measured dimension matched my circumference.

Step 5: Alignment. We now need to space the text equally from both sides. Create a center line on the top surface of the ring. Apply a vertical constraint from the top of the A there should be a snap point available there and the center line. This will allow the text to slide freely up and down that line, allowing us to create different combinations. Step 6: Parameters. The first parameter that we need to define is the total font size. Measure from the top of the A to the top of the B.

This is a critical dimension, because we will be using it to create an equation to define the letter. The second parameter is the letter number. This defines what letter is going to be used as the combination ex. For the moment, define it as 1. This should make A the correct character. Step 7: Constrain. First, we need to get a point to constrain to. Project the center line used to create the revolve you might need to use a work axis through the center of the ring.

Once that is in place, you can move on to actually constraining the text. First, create a dimension from the top of the A again using the snap point and the line that you just created.

Then, we need to use the CharacterNumber parameter that we defined, and the font size to create the equation. The reason it is CharacterNumber-1 is because we want A to equal 1.

Without that -1, the text would be off by one character. This equation allows us to change the CharacterNumber parameter and easily change the password text. Step 8: We are now going to emboss the text into the surface of the letters. Apply the Wrap to Face option, and select the outside face of the ring. This will now wrap the text around the ring.

I used a depth of. Add Tip.

CHAMINADE CONCERTINO FOR FLUTE AND PIANO PDF

Cardboard Cryptex Safe!

.

FORMULAIRE DE DEMANDE DE PASSEPORT BIOMETRIQUE IVOIRIEN PDF

Reset Password

.

Related Articles