Intermatic HomeSettings HA07C Zwave Master Remote Controller Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. Press the MODE button to cycle intermxtic the operation methods available. For additional information, see the Global Shipping Program terms and conditions — opens in a new window or tab No additional import charges on delivery Delivery: Seller information dpjbl Repeaters can re-transmit the Ya07 signal to ensure that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots. If this ON event will control scenes using dimming modules and you want to protect dimming levels already set, press and release the ALL ON button. Ihtermatic are 1 items available. Now everyone go enjoy your weekends!!!

Author:Taura Shagrel
Language:English (Spanish)
Published (Last):20 November 2005
PDF File Size:12.96 Mb
ePub File Size:17.56 Mb
Price:Free* [*Free Regsitration Required]

Jump to: navigation , search If the remote has already been included in another Z-Wave network, you need to do a factory reset on it first, as explained below, before you can add it to Vera.

Be sure the remote is not already paired with another network. Both the red and green LEDs at the top will flash. The green LED will flash while configuration is transferred. The green LED will turn solid for 2 seconds upon successful transfer, or both will flash for 2 seconds on failure. If not, reload the web page. Pick the room the remote is in, and give the remote a name if you want. If you do not want Vera to assign scenes to the remote, but will do that using another device, you can stop here.

If you want Vera to assign scenes, keep going with step 5. Check the box "Treat scene buttons as events". Then choose the scene controller from the pull-down. Then enter the scene button you want to trigger the scene; enter a number between 1 and 5 for the 5 scene buttons. After you save your changes, turning on the scene button triggers the scene.

Note that the scene can include delays. But, you might not want the bedroom lights to go off immediately if the scene controller is on the opposite side of the room from the bed. So, in the scene, for the bedroom lights, choose the command "On" then choose "After 30 seconds", then "Set a new setting", then "Off". This way, when you choose the scene, the bedroom lights will come on for 30 seconds so you have time to walk across the room, and then turn off.

Turning the scene on triggers the scenes 1 through 5. Turning the scene off does not turn the devices in the scene off as you would expect. Rather, turning off any of the 5 buttons causing Vera to trigger scene 0. You can create a scene as described above, and in step 6 choose button 0. But this means that no matter which of the 5 scene buttons you turn off, they all trigger the scene for button 0.

See ZWave Add Controller method 2 for an explanation. So, using this method, the normal way to turn off the lights is to have a scene which turns the devices off and assigns it to a button.

As explained in ZWave Add Controller you can leave "Treat scene buttons as events" unchecked, and then create scenes the traditional Z-Wave way ie Method 1. In this case the scene off works as you would expect. However, the scenes are much more limited. You cannot have delays, or adjust thermostats, or lock doors and so on. Reset Scenes Only: 1.

ASTM F1346-91 PDF


Mezikazahn Astronomic-controlled sunrise or intermatid — explained on page Your wish list is currently empty. Sign in to check out Check out as guest. Minimum monthly payments are required. Buy only this item Close this window.



With these products Ease of installation. Manual override. RF signal reliability — each Home Settings product has a special repeater feature that virtually guarantees that RF signals are received. Setting up the system is simple.

Related Articles